Multi Centre Chuck V.21
SKU:
A$455.00
A$455.00
per item
The Multi Centre Chuck V.21 now mounts directly to your lathe spindle via an adaptor (Insert). This allows you to put details in your work that are not concentric with your lathe spindle. The amount of offset ( 0 -30mm ~ in 5mm Increments ) is easily adjusted using a hex key and the amount of offset is visible in a viewing window on the chuck. Of course you can set the chuck offset to 0 and machine on centre as normal. ( Using the chuck as a screw face plate.)
You also have the ability to index your job around in equal divisions allowing you to produce complex patterns and even square or triangular shapes, example 2=180 deg,3=120 deg,4=90 deg,6=60 deg, Your imagination is the only limit to your design.
​
If your thread size is not listed, please email us. Other thread sizes may be available upon request. ​Not Suitable for Small Lathes.​​
You also have the ability to index your job around in equal divisions allowing you to produce complex patterns and even square or triangular shapes, example 2=180 deg,3=120 deg,4=90 deg,6=60 deg, Your imagination is the only limit to your design.
​
If your thread size is not listed, please email us. Other thread sizes may be available upon request. ​Not Suitable for Small Lathes.​​
Turned samples
|
Timber piece turned on the MCC
V.21
|
|
MCC VIDEO 1 V.16 - Introduction Bangle/Pendant
MCC VIDEO 5 V.16 - Lid Pepper Grinder
|
MCC VIDEO 2 V.16 - Lidded Box
|
MCC VIDEO 3 V.16 - Pencil Holder
MCC VIDEO 6 V.16 - Small Knob
|